Solarbotics

Vibrating Disk Motor - 14mm (0.55") diameter, 3.5mm (0.15") thick. This little vibe motor is quite unique in that it is fully self-contained - no v...

Pager motor technology has made it easier for us to find a suitable replacement for the original TPM for substantially less! Want to build somethi...

These 1/8" square, clear-epoxy encapsulated solarcells are good for 0.475 volts (open circuit) @ 1.86mA (short circuit) in noon sunlight. Note: y...

This high-power motor fits in the GM2/3/8/9 series of gear motors, offering approximately 3 times the speed, twice the torque and quadruple the pow...

This 030 form-factor motor with precious-metal brushes offers pretty good performance for a flat-sided motor. Offering 7400 rpm @ 4.7V, drawing 150...

This is a soothing little marble mill that sends balls down a spiral ramp and cycles them back with a mill wheel. All it needs is some solar energy...

This is a soothing little marble mill that sends balls down a spiral ramp and cycles them back with a mill wheel. This version of the kit chugs alo...

Want to turn a servo into a more powerful gear motor? This kit replaces the guts of a standard servo with a logic-signal friendly L293D motor drive...

The GM8 is much like the GM2 gear motor but runs at nearly twice the speed. This 143:1 gear motor spins at 70RPM at 5V, drawing 670mA at stall gene...

The GM7 is a baby version of the popular GM3 gear motor. Designed by Mark Tilden to have tighter tolerances and better performance than a regular t...

The GM6 is a baby version of the popular GM2 gear motor. Designed by Mark Tilden, the GM6 has tighter tolerances and better performance than a regu...

These impressive 224:1 gear motors are very comparable to a hobby servo for power, at a fraction of the cost! This motor offers 50 inch-ounces of t...

81:1, 370RPM, 24.6mA (184mA stall) at 5V gives 3.6in*oz torque. Not bad, eh? They're a bit funky in that they're not continuous rotation by defaul...

Borrowing design elements from the golden age of air travel, we've added our unique solar-electronics flair to create self-powered dynamic mobiles.

What's more useless than a switch that does nothing? How about a switch that activates an actuator to turn itself back off? If that sounds like the...

10mm OD 1.5mm ID 7mm wide Nylon hub

Input Voltage: DC 4.75 ~23V Output Voltage: DC 1 ~ 17V

Dimensions: 30mm x 7mm

Injection-molded ABS wheel to fit the double-flat output shaft of the GM series gearmotors. Gone are the rubber bands, replaced by molded-on thermo...

DC-DC 2A Adjustable Boost Power Supply Converter Step Up Module 2-24v

This regulator will pretty much take any voltage between 5~32V and convert it to anything between 1.25 ~35V! Unlike standard Buck converters, this ...

Need a high quality power supply for your project? Here’s a very cool piece of kit. Feed up to 40V into this guy and get anything from 1.25 – 37VD...